Installation Instructions
Download a copy of the Mobile Softwater Installation Instructions
Calclear_Mobile Softwater Installation Instructions
or follow these instructions:
The Mobile SOFTWATER CONDITIONER has a pre-wound pipe fastened inside the box with 25mm / 1” brass fittings extending at each end of the box ready to connect to 2 water supply hoses. This pipe inside the metal box is wrapped with antennae connected to our electronics sending an electronic computerised programme © through the water pipe. This signal creates an electromagnetic field through which your water supply will pass.
This field will act on the particles in the water and keep hard water minerals in solution to create softer water. This will make soaps and detergents lather and reduce scale build up on surfaces.
Installation:
Connect your main water supply hose with appropriate pipe 1” / 25mm connectors to the brass fitting at one end of the box. Note where your power supply is so it will be connected and fit accordingly.
Connect your second pipe / hose from your Winnebago inlet water hose / pipe or hot water service to the other brass fitting on the end of the box. DO NOT turn on the water until both ends of the pipes are securely connected and tightened.
Connect the second brass fitting on the box to your second water hose to be used for your Winnebago, hot water system or specified plumbing equipment.
Carefully plug your water proof power pack into your external power supply. The powerpack is water proof but DO NOT turn on until the water has been connected and tested. Your power supply drops the power down to the 12v 1 Amp power needed and does not have a harmful electronic signal.
Turn on the water gently and test flow until required moderate flow is achieved . Turn off immediately if water is leaking.
Once water has been connected safely, turn on your power supply at electricity and lights will alternate. You should also hear a gentle “whistling” noise of the signals being created in the box.
Your water supply should now be treated to become softer. The water should feel “slippery” . This can descale showers and taps that are already covered in scale. Be aware that there may be scale in your pipes which will be dislodged by the new Mobile Softwater Conditioner and may come out of the pipes in the early days.
Enjoy your Mobile Softwater! ™
For more information contact our technical department: info@calclear.com.au or phone +612 9977 8801
Print page